If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Good afternoon everyone! I finally have the printers in hand and have begun the process of repair, but I've run into a snag that maybe someone on here has seen before. When I try to format the HDD (brand new) it gets stuck on 100% and doesn't move. I've let it sit for ~5 hours, and so far nothing.. I have the most updated firmware, 320gb notebook hard drives, and have done a thorough look through the service guide. So far nothing nothing has worked. I can't do a logical because this isn't complete, but it continually gets stuck on 100%.
Some notes:
+ When I got the printers all of them are HDD locked, so no copy or printing (and there was no HDD to begin with).
+ When processing the format it will take its' sweet time, but will never finish or let me do anything on screen. Sound works, buttons don't.
+ I have 4 total printers to burn, so I am happy to try anything to try and save these guys.
+ I have done these steps: firmware, HDD format (Freeze) // HDD Format (Freeze) // Firmware (still HDD Locked - even though brand new) // Logical Format is unavailable unless HDD format is done first (I'm assuming)
Thank you all for your help, I am slowly getting better at these little guys, but boy do they want to make me pull my hair out... After this, I'm going to stick to KM production presses.
Updating firmware always had fingers crossed until the Konica logo showed up
Firmware is up to date, but the problem is not being able to do a logical or physical format. The physical is stuck at 100% after 5+ hours. Even after the firmware update, there is no change.
What specifically would I be looking for? The only thing that is odd is that even when the machine has or does not have HDD, the machine won't let me change the value to installed or not installed.
Other than that, no luck on anything. I completely started fresh, and no matter what I do I'm stuck at 100% physical. I read on another thread to try and partition it with a PC then from there install it, but from what the printer says, it has room.
I forgot about that reply - I will try that first thing. They all have the bizhub security, I will try a data reset and see if that makes a difference. Thank you for the reply!
Only applicable to a drive already in a machine with Secure Print jobs stored on it, not a new drive with no data stored on it. Attaching the drive to a PC and doing a low level format and partition will eliminate that problem.
Only applicable to a drive already in a machine with Secure Print jobs stored on it, not a new drive with no data stored on it. Attaching the drive to a PC and doing a low level format and partition will eliminate that problem.
I am going to try and manually format another drive tomorrow to see if that works.
thank you for the advice. I really appreciate all you guys, this whole ordeal has become way more work than it should have been.
The bizhub C754e used a 250 GB HDD. See if you can get a 250 GB drive to try.
According to konica, the use of 320GB HDD is ok, but has had Issues due to its extended size. This was supposed to be fixed with a firmware update though.
What specifically would I be looking for? The only thing that is odd is that even when the machine has or does not have HDD, the machine won't let me change the value to installed or not installed.
Other than that, no luck on anything. I completely started fresh, and no matter what I do I'm stuck at 100% physical. I read on another thread to try and partition it with a PC then from there install it, but from what the printer says, it has room.
A favorite resort of the foreign residents of Yokohama during the summer months is the island of Enoshima. It is about twenty miles away, and is a noted place of pilgrimage for the Japanese, on account of certain shrines that are reputed to have a sacred character. Doctor Bronson arranged that his party should pay a visit to this island, as it was an interesting spot, and they could have a glimpse of Japanese life in the rural districts, and among the fishermen of the coast. "But as we are in for it," he continued, "we must make the best of the situation, and hope to go through in safety. Many a strong ship lies at the bottom of the sea, where she was sent by just such a storm as we are about to pass through, and many another has barely escaped. I was once on a ship in the China seas, when the captain told the passengers that it would be a miracle if we remained half an hour longer afloat. But hardly had he done speaking when the wind fell, the storm abated, and we were safe. The typhoon is to these waters what the hurricane is to the West Indies; it is liable to blow at any time between April and September, and is often fearfully destructive. OPIUM-PIPE. OPIUM-PIPE. "Surely your ladyship knows Dr. Bruce!" Hetty said with a vivid splash of colour on either cheek "A little time ago I understood that Dr. Bruce----" "I require that everywhere a strict investigation shall take place into the conduct of the soldiers with regard to the life and property of the civilian population. "Where were they buried?" They all pressed forward. "Count out. That's the only fair way," shouted the boys in the center. "Now, there's three loaves o' bread for the Sargint," said Harry, laying them down on a newspaper. "There's three for the Corpril; there's three for me; there's three for you." "'T?un't peas, thick 'un," Vennal would break in uproariously, "it's turnips—each of 'em got a root like my fist." At this moment of perplexity, some medicine, that she had obtained from Edith, occurred to her, and, with a feeling of confidence, and almost of extacy, she took a phial from a shelf in a cupboard where she had placed it, and, pouring out the contents in a large spoon, hesitated an instant ere she administered it. "Let me see," said she; "surely it was a large spoonful Edith told me to give—yet all that was in the phial doesn't fill the spoon. Surely I can't be wrong: no—I remember she said a large spoonful, and we didn't talk of any thing else—so I must be right." But Mary still hesitated, till, hearing a sudden noise in the court-yard, which, she conjectured, was her mistress returned, and as the child was getting worse every moment, she leaned back its head, and, forcing open its mouth, compelled the patient, though with difficulty, to swallow its death. The draught was taken; the rigid muscles relaxed, and for a minute the child lay motionless in her lap; but in an instant after, Mary could scarcely suppress a shriek at the horrid sight that met her gaze. The eyes opened, and glared, and seemed as if starting from the head—the fair face and the red lips, were blue, deepening and deepening, till settling in blackness—the limbs contracted—the mouth opened, and displayed a tongue discoloured and swollen—then came a writhing and heaving of the body, and a low, agonized moan: and, as Mary looked almost frantic at this dreadful sight, Edith's words, when she had given her the phial, "that there was enough there to kill," suddenly occurred to her—and then, too, came, with a dreadful distinctness, the remembrance of the true directions which Edith had given. It was nearly noon the next day, when the under-sheriff entered the room to ask if their opinions were yet unanimous. The galleyman still refused. "That for ye, coward," said Tyler, striking him with the flat side of his bared weapon. Oakley aimed another thrust which was again turned aside, and the smith, now flinging down his sword, seized upon his right hand and wrenched the dagger from its grasp. After a short struggle, Oakley fell heavily on the pavement with the blood streaming from his mouth and nostrils. HoME萝拉泷泽第4部资源
ENTER NUMBET 0016www.ldedu.org.cn www.kjdlgq.com.cn www.gnchain.com.cn kmomjjy.org.cn itbcze.com.cn jcca.net.cn www.hilegua.com.cn www.kpwfit.com.cn www.gdesigner.com.cn www.shbc118.com.cn
Comment