If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
I've been having way too many of these turds severely undertone themselves (usually black) and I've finally caught one in the act today.
The customer was printing a duplex 11x17 document with heavy black text, and high density red and orange images. Black was totally trashed, but the magenta was just starting to go.
ID sensors were nasty, so I cleaned everything up and tried to force add toner to M and K - to my surprise, Black density came back up nicely but Magenta would not, and finally came up with a toner near end condition on a nearly full bag.
The toner line was clean, so I tore down the pump (yuck!) and it had gotten hot enough to fuse a big clump of toner right in the inlet as well as chunks all through the screw and it had the rubber worn out and breaking down.
Has anybody else seen this?
Given the number of chunks I've had to clean from behind the doc blades on these machines, I suspect this is happening to a lesser degree quite frequently.
I also suspect since the toner in this machine is 10% carrier that the abrasiveness may be wearing the pump causing them to run less efficiently and produce more heat (maybe why the lowered the content in the Pro C700 and C900)
Thoughts???
If this is common I may start replacing the pumps on some sort of PM basis - it would save me a lot of trouble to get these beasts running on par with their predecessors.
I haven't put any more in than I did with the 3260. Any I have had a problem with I didn't take them apart I just put a new one in.
How are you cleaning behind the doctor blades ? mylar thing ? It would be nice if they would put a tool out to line it up so I could just take them off to clean. I had so many problems with that on the 3260 I was carrying developer units. I haven't been having a problem with the MPC6000.
We have a customer with around 550k color and we had to replace both cyan and magenta pumps. The pumps are sealed and it stinks because each pump costs $240. I was going to replace all four since cyan went first then a week later magenta went. What a piece of crap we all try to avoid going to them at all costs lol.
My machine has about 500k on it as well, and would have more if they could depend on it for production. I'm trying to get it upgraded to a C900 and eventually pull a press out.
I only pulled that pump apart out of desparation - the customer had a big job, and I had already been longer than I wanted getting to them. I can see why they make it an assembly - its a big mess.
Never had a problem with the pumps yet on my machines but my colleagues are replacing them in accounts where customers runs those machines as color production units.
Big mistake to consider a 6000 or Pro 550 a color production machine. It can not keep up...neither the toner add system, neither the cleaning system.
If this machine will have cleaning brushes, blades and drums like 2060...it will be something
Definitely is something wrong with this toner/ dev combination that is causing the chunks, especially in low humidity conditions.
Winter is around the corner and everybody started already the heating systems...so it will be fun, fun, fun.
The loner has a much lower melting point these days so that is why if it gets hotor even warm say in your car it starts to melt together>AS for the black washing out here is an idea that when i next go to one i am going to try. In the service manuale look at SP3101 1 to 4 it gives the idea that the black patch is to reflective so it would undertone by changing the way the patch is printed it may keep up with toner demand better i dont often go to these machines but it may be worth trying
A favorite resort of the foreign residents of Yokohama during the summer months is the island of Enoshima. It is about twenty miles away, and is a noted place of pilgrimage for the Japanese, on account of certain shrines that are reputed to have a sacred character. Doctor Bronson arranged that his party should pay a visit to this island, as it was an interesting spot, and they could have a glimpse of Japanese life in the rural districts, and among the fishermen of the coast. "But as we are in for it," he continued, "we must make the best of the situation, and hope to go through in safety. Many a strong ship lies at the bottom of the sea, where she was sent by just such a storm as we are about to pass through, and many another has barely escaped. I was once on a ship in the China seas, when the captain told the passengers that it would be a miracle if we remained half an hour longer afloat. But hardly had he done speaking when the wind fell, the storm abated, and we were safe. The typhoon is to these waters what the hurricane is to the West Indies; it is liable to blow at any time between April and September, and is often fearfully destructive. OPIUM-PIPE. OPIUM-PIPE. "Surely your ladyship knows Dr. Bruce!" Hetty said with a vivid splash of colour on either cheek "A little time ago I understood that Dr. Bruce----" "I require that everywhere a strict investigation shall take place into the conduct of the soldiers with regard to the life and property of the civilian population. "Where were they buried?" They all pressed forward. "Count out. That's the only fair way," shouted the boys in the center. "Now, there's three loaves o' bread for the Sargint," said Harry, laying them down on a newspaper. "There's three for the Corpril; there's three for me; there's three for you." "'T?un't peas, thick 'un," Vennal would break in uproariously, "it's turnips—each of 'em got a root like my fist." At this moment of perplexity, some medicine, that she had obtained from Edith, occurred to her, and, with a feeling of confidence, and almost of extacy, she took a phial from a shelf in a cupboard where she had placed it, and, pouring out the contents in a large spoon, hesitated an instant ere she administered it. "Let me see," said she; "surely it was a large spoonful Edith told me to give—yet all that was in the phial doesn't fill the spoon. Surely I can't be wrong: no—I remember she said a large spoonful, and we didn't talk of any thing else—so I must be right." But Mary still hesitated, till, hearing a sudden noise in the court-yard, which, she conjectured, was her mistress returned, and as the child was getting worse every moment, she leaned back its head, and, forcing open its mouth, compelled the patient, though with difficulty, to swallow its death. The draught was taken; the rigid muscles relaxed, and for a minute the child lay motionless in her lap; but in an instant after, Mary could scarcely suppress a shriek at the horrid sight that met her gaze. The eyes opened, and glared, and seemed as if starting from the head—the fair face and the red lips, were blue, deepening and deepening, till settling in blackness—the limbs contracted—the mouth opened, and displayed a tongue discoloured and swollen—then came a writhing and heaving of the body, and a low, agonized moan: and, as Mary looked almost frantic at this dreadful sight, Edith's words, when she had given her the phial, "that there was enough there to kill," suddenly occurred to her—and then, too, came, with a dreadful distinctness, the remembrance of the true directions which Edith had given. It was nearly noon the next day, when the under-sheriff entered the room to ask if their opinions were yet unanimous. The galleyman still refused. "That for ye, coward," said Tyler, striking him with the flat side of his bared weapon. Oakley aimed another thrust which was again turned aside, and the smith, now flinging down his sword, seized upon his right hand and wrenched the dagger from its grasp. After a short struggle, Oakley fell heavily on the pavement with the blood streaming from his mouth and nostrils. HoME萝拉泷泽第4部资源
ENTER NUMBET 0016www.jexdic.com.cn www.hlchain.com.cn laoguai.com.cn www.jnihfs.com.cn gbngqw.com.cn www.ochygj.com.cn nnnmmm.com.cn www.ohf2e.org.cn qurong123.com.cn www.xfnccq.com.cn
Comment